Solid-state contactor for DC loads
PK 9265
The PK 9265 solid-state contactor from the POWERSWITCH series is designed as a switch for DC loads. When the control voltage is applied, the load circuit at the output of the solid-state contactor is switched through. The LED indicator signals the status of the control input. The semiconductor principle eliminates the disadvantages of electromechanical relays, which manifest themselves, for example, in the form of arcing (especially with DC loads) and contact bounce. This results in a longer service life and higher current carrying capacity for the solid-state contactor.
| Load current up to: | 25 A |
|---|---|
| Load voltage up to: | AC 300 V |
| Number of poles: | 1-pole |
| On/Off Input Control: | DC |
| Type: | PK 9265 |
| Widths: | 22,5 mm |
- Low input current control
- Protected against slow varying input control voltages
- Built-in overvoltage protection
- Low off-state leakage current
- Very low on-state resistance
- Resistant to physical shocks and vibrations according to IEC/EN 60068-2-6
- High switching cycles, low maintenance
- Silent switching
- Can be used as a high-side driver or a low-side driver
MOSFET Power semiconductor
Maximum transient peak voltage: 100 V and 600 V
DIN Rail mount with integral heat sink
No radiated or conducted interference
IP20 Touch protected housing